Page 22
CK and EQ Manual
Set Time of Day
The user can also set the time of day. Time of day should only need to be set if the battery has been depleted because of extended
power outages or when daylight saving time begins or ends. If an extended power outage occurs, the time of day will flash on and
off which indicates the time of day should be reset. The non rechargeable battery should also be replaced.
Regeneration Mode
Typically a system is set to regenerate at a time of low water usage. An example of a time with
low water usage is when a household is asleep. If there is a demand for water when the system is
regenerating, untreated water will be used.
When the system begins to regenerate, the display will change to include information about the
step of the regeneration process and the time remaining for that step to be completed. The current
cycle display will alternate with the regen time remaining screen. The system runs through the
steps automatically and will reset itself to provide treated water when the regeneration has been
completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when
the system calls for it, usually referred to as manual regeneration. There
may be a period of heavy water usage because
of guests or a heavy laundry day.
To initiate a manual regeneration at the preset delayed regeneration time, when the regeneration time option is set to
“DELAYED REGEN” or “BOTH”, press and release “REGEN”. The words “REGEN TODAY” will periodically be shown
on the display to indicate that the system will regenerate at the preset delayed regeneration time. If you pressed the “REGEN”
button in error, pressing the button again will cancel the request. Note: If the regeneration time option is set to “IMMEDIATE
REGEN” there is no set delayed regeneration time so “REGEN TODAY” will not activate if “REGEN” button is pressed.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for three seconds. The system will begin
to regenerate immediately. The request cannot be cancelled.
Note: For softeners, if brine tank does not contain salt, fill with salt and wait at least two hours before regenerating.
STEP 1U
STEP 1U – Press CLOCK.
STEP 2U
STEP 2U - Current Time (hour): Set the hour of the day using
▼
or
▲
. Press NEXT to go to Step
3U.
STEP 3U
STEP 3U - Current Time (minutes): Set the minutes of the day using
▼
or
▲
. Press NEXT to exit
Set Time of Day. Press REGEN to return to previous step.
RETURN TO NORMAL MODE
DISPLAYS
ALTERNATE
BEING VIEWED
