Water Right Sanitizer Plus Series, Инструкция по установке и руководство пользователя

Страница: 11 / 30

10 11
3
If the system has called for a regeneration that will occur at the preset time of regeneration, the words
“REGEN TODAY” will appear on the display .
If a water meter is installed, “GPM” flashes on the display when water is being treated, indicating gallons
per minute going through the system .
2 .
REGENERATION MODE:
Typically a system is set to regenerate at a
time of no water usage . If there is a demand for water when the system is
regenerating, untreated water will be delivered . When the system begins
to regenerate, the display will change to include information about the
step of the regeneration process and the time remaining for that step to be
completed . The system runs through the steps automatically and will reset
itself to provide treated water when the regeneration has been completed .
3 .
MANUAL REGENERATION:
Sometimes there is a need to regenerate
before the control valve calls for it . This may be needed if a period of heavy
water use is anticipated or when the system has been operated without salt .
• To initiate a manual regeneration at the next preset regeneration time,
press and release
regen
. The words “REGEN TODAY” will flash
on the display to indicate that the system will regenerate at the next
regeneration time (set in Programming, steps 4 and 5) . If you pressed
the
regen
button in error, pressing the button again will cancel the
command.
• To initiate a manual regeneration immediately, press and hold the
regen
button for three seconds . The system will begin to regenerate
immediately .
This command cannot be cancelled.
Once a manual regeneration is initiated, the unit will go into the FILL position . This position allows water to enter the brine
tank until it reaches the proper level . Once this position is complete, you will notice a 240 Minute (4 hours) SOFTENING
position . This 4-hour window allows the salt to dissolve and achieve proper brine strength . During these FILL and SOFTENING
positions, you will have softened water available for use . Once the unit advances to the BACKWASH position and
subsequent positions thereafter (see Start Up Instructions for regeneration sequence), the water softener will deliver water, but
it will be untreated .
IMPORTANT:
With the Dry Salt Storage Feature, the brine tank will refill 4
hours before the actual regeneration occurs . You may experience a small amount
of noise for a short period of time at 10:00 p .m . (with typical setting) on the
night that regeneration is to occur . This noise is only the brine tank filling and at
no time during this process will you be without treated water .
4 . POWER LOSS AND BATTERY REPLACEMENT: The AC transformer comes
with a 15 foot power cord and is designed for use with the control valve; the
transformer should only be used in a dry location .
In the event of a power outage, the control valve will remember all settings and
time of day . If an extended power outage occurs, the control valve will keep time
of day until the battery is depleted . When the battery becomes depleted, the only
item that needs to be reset is the time of day and will be indicated by the time of
day flashing . All other settings are permanently stored in the nonvolatile memory .
If a power loss occurs and the time of day flashes, this indicates that the battery
is depleted . The time of day should be reset and the non-rechargeable battery
BACKWASH
8:22
REGENERATION MODE
MANUAL REGENERATION
REGEN TODAY MON
GPM
2:40 8
PM
REGEN TODAY and TIME OF DAY
will flash alternately if a regeneration
is expected tonight.
4
DAYS TO A REGEN
GPM
3 8
CAPACITY REMAINING
GPM GAL
1600
8
BATTERY REPLACEMENT