Measurement sources can be stored on the PoolLab 2.0 in order to assign the measurement results to these measurement sources.
To store measurement sources on the PoolLab 2.0, proceed as follows
1)
Connect PoolLab 2.0 with the LabCOM App (as shown on the previous pages)
2)
Tap the spanner next to "Sampling Points
3)
The "Sampling Points" list that appears corresponds to the measurement sources individually stored in the LabCOM app.
4)
Check the box for max. 20 measuring sources to be transferred to PoolLab 2.0
5)
Tap OK
From this point on the PoolLab 2.0 can be used via the Sampling Point button or via the menu
to select the measurement source under which the following measurements are to be saved.
Note:
If Sampling Points are transferred to PoolLab 2.0 before the cloud account is set to
the PoolLab 2.0 is set up (see previous page), the sampling points have to be
Set up the cloud on the PoolLab 2.0 again.
Note:
If the cloud has already been set up on the PoolLab 2.0 and a WiFi connection has also been set up
connection has been set up on the PoolLab 2.0, after transferring the
sampling points on the PoolLab 2.0, the WIFi button must be pressed once to activate the
to synchronise the transmitted sampling points with the cloud.
PoolLab 2.0
(transfer measuring sources)
