Page 10
For technical questions, please call 1-888-866-5797.
Item 59437
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Inserting a Bit in the Tool
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off, wait for the motor to stop, and remove
the battery pack before adjusting tool or installing accessories.
TO pREVENT SERIOUS INJURy FROM AccESSORy FAILURE:
Only use accessories that are rated at or above the RpM rating of the cordless Rotary Tool.
1. Depress the Spindle Lock.
Rotate Collet until spindle shaft
is engaged by the Lock.
2. Loosen the Collet Nut by turning
it counterclockwise, using
the Wrench provided.
Wrench
Bit
Spindle
Lock
collet
WARNING!
When changing a bit immediately
after use, be careful not to touch the bit. It may
be very hot from use, possibly causing serious
injury. Allow the bit time to cool before handling.
3.
To remove a Bit:
Pull the bit straight out
of the Collet once the Collet Nut is loose.
To insert a Bit:
Insert the shank end of the
bit into the Collet once the Collet Nut is loose.
NOTE:
Your tool is provided with a 1/8″ diameter
Collet. This is precision manufactured to fit
comparably sized bits.
Do not force a wrong sized Bit into the Collet,
and do not modify a mismatched Collet or Bit.
Severe personal or property damage may
result from using a mismatched collet or Bits.
4. Tighten Collet Nut securely using the
provided Wrench. Ensure that the Spindle
Lock is released before turning on the tool.
General Operating Instructions
1. Press and hold the Power Button for
1~2 seconds to turn the tool on.
2. The tool bit speed is adjustable (1 LED is
slowest, 5 LED’s is fastest). Tool will always
start at level 3 (3 LED’s.)
To increase speed:
Press the ″+″ Speed
Control Button.
To decrease speed:
Press the ″-″ Speed
Control Button.
NOTE:
Use a speed appropriate to the bit
and the material being worked on. In general,
harder materials require faster speeds and
softer materials require slower speeds.
WARNING: Do not change the
speed while the tool is working.
3. Apply the tool bit to the work
material as needed.
4. When the task has been completed, stop
the tool by pressing the Power Button.
5. Unplug the rechargeable Battery Pack.
Remove the bit or attachment as
discussed in the previous section.
6. Store the tool, its Battery Pack,
and its Bits and Attachments in
their case in a safe location.
power
Button
Speed control
Button ″+″
Speed control
Button ″-″
LED Speed
Indicator
Record product’s Serial Number Here:
Note:
If product has no serial number, record month and year of purchase instead.
Note:
Specify UPC 193175470973 when ordering parts.
