Page 9
For technical questions, please call 1-888-866-5797.
Item 59437
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TOOL SET Up
Battery charging
charging the Battery pack
Battery packs are normally shipped with low or
no charge to prevent potential problems during
shipment. Charge the battery pack before use.
Note:
Batteries will not reach full charge the
first time they are charged. Allow several
cycles (operation followed by recharging)
before the battery will become fully charged.
WARNING!
Battery explosion may cause serious
personal or property injury including death.
Charge the battery only within a 50° to 100° F
room temperature. Lower temperatures
may inhibit charging. Higher temperatures
increase chance of battery failure.
1. Charge the Battery Pack only with the
included Charger. Use of other chargers may
cause battery failure including explosion.
2. Plug Charger cord into Battery Pack. Plug
the Charger into a 120 VAC wall outlet.
3. Ensure that the Charger is connected
to a circuit breaker protected 120
VAC, 60 Hz power supply only.
4. While charging, the LED on the Charger
glows red, indicating that the Charger is in
operation. During recharging, the Battery
Pack will become slightly warm to the touch.
This is normal and not a cause for concern.
5. When the Battery Pack is fully charged
(3-5 hours), the LED turns green,
indicating charging is complete.
Note: The charger will not shut off
automatically.
When the LED turns
green indicating the Battery Pack is fully
charged, unplug the Charger from the
Battery Pack. Do not leave the Battery Pack
plugged into the Charger indefinitely.
Do not place the Battery Pack and Charger
in an environment of extreme heat or cold.
They will work best at room temperature.
Installing the Battery pack
1. Slide the Battery Pack into the tool making
sure the Release Button snaps into place.
2. Make sure that the Battery Pack is secure
in the tool before beginning use.
Removing the Battery pack
1. Press the Release Button on the Battery
Pack to release it from the tool.
2. Remove the Battery Pack from the
tool by sliding it out backward.
Workpiece And Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Secure loose workpieces using
a vise or clamps (not included)
to prevent movement while working.
3. There must not be objects, nearby that
will present a hazard while working.
