Warren Elevating 5
th
Wheel
28
Install Ramps
Using 1/2 x 3 inch flat stock, cut stock long enough to go from A to B leaving enough extra to go
down the face of the frame to C. Begin by welding at point B.
Weld from B to A.
Heat point A and bend stock over the end of the tractor frame to E.
Weld from point A to E.
Cut off excess stock if any.
If there are any gaps between the pickup ramp and truck frame, cut 3/8 inch stock to make a brace
centered under the pickup ramp.
Severe Duty Applications
If your 5
th
Wheel will be used in severe duty, it may require additional bracing. Please contact
your installer or Warren Truck and Trailer for more information.
Connect Hydraulic Hoses, Pump
Figure 11. Hydraulic layout for FW-30
