©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
3
87687 A1
N O T I C E
EQUIPMENT DAMAGE
• Always refer to the Installation and Specification Guide, supplied in the winch kit, for all wiring schematics and specific details on how to wire this WARN product to your vehicle.
•
Never overtighten the j-bolt to the bracket. Doing so will pinch the winch cable against the bracket, damaging the cable.
•
Always put the end of the actuator cable through the slot in the Termination Bracket. Terminating the cable through any other hole in the bracket will cause the bracket to not
function properly and will drastically reduce the life of the actuator cable.
Read installation and operating instructions thoroughly.
C A U T I O N
MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to minor or moderate injury
•
Always take time to fully read and understand the installation and Operations Guide included with this product.
•
Never operate this product if you are under 16 years of age.
• Never operate this product when under the influence of drugs, alcohol or medications.
Read installation and operating instructions thoroughly.
Note:
The following steps describe the method for raising the plow with a winch. If you are using an electric actuator or manual
lift, please follow the instructions included in those kits.
1. Attach the J-bolt bracket (C1) to the plow cross-member
using the supplied 3/8-16 X 1 hex bolt (B6), 3/8 flat
washer (B7) and 3/8-16 lock nut (B8). The bracket should
be installed in the plow blade side of the cross-member.
Attach the 3/8 bolt (B6) such that the head of the bolt is
inside the bracket and the threaded end points towards the
ATV.
Note: If using older version of plow lift, see Figure 1. If using
newer version of plow lift, see Figure 2.
2. Route the winch cable down over the roller fairlead and to
the J-bolt bracket. Slide the loop end of the winch cable
over the hook of the J-bolt. If a winch hook is attached
to the loop end of the cable, position it out of the way or
remove it.
3. Slide the J-bolt down through the round hole in the J-bolt
bracket and terminate with the supplied 1/4 flat washer
(B10) and 1/4-20 lock nut (B11). The curved end of the
J-bolt should be sitting in the slotted hole in the bracket.
Note: If you’re using a winch to lift the plow, you will need a
Roller Fairlead if one is not already installed. A Cast-Iron
Hawse Fairlead will not work.
Figure 1 -
Older version
C1
B6,B7 & B8
Figure 3 -
J-Bolt Bracket and Winch
I N S T A L L A T I O N I N S T R U C T I O N S
Figure 2 -
Newer Version
