©2018 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
4
102494A0
I N S T A L L A T I O N I N S T R U C T I O N S
1. Remove factory bumper.
2. If reusing fog lights, be sure to remove from stock bumper.
3. Use a small flat head screwdriver to pry wire harness clips
upward.
4. Disconnect fog light harness Christmas tree clips from the
factory bumper.
NOTE: You will need to secure wiring up in new bumper with
zip ties.
5. Install the eight 1/2” carriage bolts (B1) into the bumper
mounting slot (four each side).
IMPORTANT: Be sure that bolts are completely seated
in bumper (with square edges lined up with slot) before
securing push nut.
Aline
edges
Figure 1
Figure 2
Figure 3
Figure 4
