7
6
WARMUP INC.
USA: [email protected] | Tel.: 1-888-927-6333 | www.warmup.com
CANADA: [email protected] | Tel.: 1-888-592-7687 | www.warmup.ca
TOWEL WARMER INSTALLATION INSTRUCTIONS
FOR MODELS TW001 AND TW002
MOUNTING INSTRUCTIONS
Mounting bracket to secure
towel bars on the right side
Align left side to studs
Remove drywall section
to mount towel warmer
All bars are right-hand hard wired connections. This means the left side of your horizontal bars will need to line up on a
stud. Use a stud-finder to locate the stud and mark the placement of the towel warmer with a pencil. Then proceed as
above with cutting out the drywall for mounting.
Your TW001 or TW002 bars will be supplied with a mounting rail. This mounting rail will be secured on the right hand side
of the rails (right side when facing the towel warmer on the wall).
The single bar rails are individual heated bars installed horizontally in a ‘landscape’ direction, one on top of the other to
create an aesthetic floating ‘ladder’ feature in the bathroom. The installation of this model requires access behind the
drywall and should be completed before hanging drywall. In other instances, mark the placement of the towel warmer
and cut out the drywall at least 6” wider around the towel warmer. Remove the drywall cutout from the wall and proceed
with mounting instructions below.
Stud
Mount 4 towel bars at 160mm spacing (6-1/2”) or up to 8 bars at 80mm spacing (3-1/4”). To connect up to 8 bars at
6-1/2” spacing, mount two mounting brackets. Warmup will supply you with one bracket with each set of 4 towel bars.
While not recommended, you can trim the mounting bar if required (for example, if using less than 4 bars). The maximum
spacing between the top bar and the bottom bar would be 60”. The leads exiting each bar are 3ft. You would have to make
provisions to ensure the leads connect centrally to a junction box.
Power cord entry on the right side
