TOWEL WARMER INSTALLATION INSTRUCTIONS
8
WARMUP INC.
USA: [email protected] | Tel.: 1-888-927-6333 | www.warmup.com
CANADA: [email protected] | Tel.: 1-888-592-7687 | www.warmup.ca
With TW001 and TW002 models, the j-box or connection point will be located away from the bottom right of your towel warmer.
This can either be near the appliance or directly into a switch box or gang box hosting your Warmup 4iE controller (optional).
Do note that the leads exiting each bar are 3ft in length. Do not extend these leads in the wall outside of a code compliant junction
box. It is not safe to make electrical connections outside of a junction box.
Please ensure you comply to all local and national code requirements in regards to line voltage wire in conduit. State and local
regulations vary (flex conduit, rigid conduit or neither) and must be respected to avoid electrical hazards.
The installation of this model requires access behind the drywall and should be completed before hanging drywall. In other
instances, mark the placement of the towel warmer and cut out the drywall at least 6” wider around the towel warmer.
Remove the drywall cutout from the wall and proceed with mounting instructions below:
1. Mount the concealed cable mushroom into the wall where the lower right hand bracket will be located
(lower right as you look at the mounted towel warmer on the wall)
2.
Ensure you have a code compliant connection between the mushroom anchor and your electrical connection in the j-box.
3. Determine the other anchor points and secure the wall anchors accordingly.
a) This will be specifically identified by the location of the mounting bracket bar secured to the back of the drywall panel
4. You must ensure that the left side of the towel warmer is secured to wood or metal studs or a structural element.
5. Your lead wires are 3ft leaving each bar. You can trim it to your needs leaving no less than 12” outside of the towel warmer
6. Sleeve the cables through the wall anchor mushrooms and fish them through to your electrical connection. All electrical
connections and wiring must be compliant with local and national electrical codes. Please check with a licensed electrician.
7. Finally safely push your towel bars into place and tighten the grub screws underneath each bracket.
CONCEALED CORD ENTRY WITH REMOTE J-BOX
Your package includes:
1
4
2
5
3
6
7
x1
x1
x3
x1
Mushroom kit with
screw and washer
