4
24/7 Technical hotline - Ligne d’assistance technique - Línea de asistencia técnica
US 1.888.927.6333 / CA 1.888.592.7687
GETTING STARTED
1. Language
2.
Time perefrences and settings
3.
Date preference and settings
4.
Daylight savings
5.
Temperature preferences
6. Theme
7. Brightness
8.
Standby Brightness
9.
Heating LED
10. Audio Feedback
11.
Floor type
12. Set heating target
13. Program schedule
14. Set energy monitor
15. (You may skip this section and
complete at a later date )
16. Energy settings
On initial power up the thermostat will guide you through set up procedure.
By accessing the main menu you can program your thermostat or make any changes to the thermostat
settings. To access the menu press “menu” on the main screen.
If the thermostat is in sleep mode press ”wake”.
L
The energy monitoring menu will be skipped automatically if a pre set program is selected on initial
setup.
Ground FAuLT CIrCuIT InTErruPTEr (cont’d)
However if the thermostat detects that one of the relays has FAILED to open correctly you will see the
Control Fault screen and the TEST LED will illuminate.
In the following circumstances you should immediately isolate the power supply to the thermostat and
contact Warmup customer service:
1.
Press the TEST button when heating is on (the red light in the top corner is on) and the screen does
not display GROUND FAULT or cut power to the load.
2.
The thermostat shows the GROUND FAULT screen during normal operation.
3.
The thermostat shows the CONTROL FAULT screen.
Note: The GFCI test should be carried out monthly.
