Product Helpline.
01733 404 702
For all your product needs.
Product Helpline.
01733 404 702
For all your product needs.
Safety Warnings:
Read the instructions in the manual carefully. it has important information both
for operation use and for your safety.
Do not use faulty appliances.
Your heater should be checked anually by a qualified person for safe operation
and to detect any fault.
Retain these instructions for future reference. if necessary, a new copy
may be obtained from your dealer.
Turn off the gas container valve after use
The appliance is suitable for 14.2kg/5.5kg LPG container, when change gas container
move the appliance to a flame-free well ventilated atmosphere.
Do not move the appliance when in operation or when cooling.
Avoid to twisting the gas hose as this may cause the hose to stress and fracture.
Turn off the regulator and disconnect the regulator from cylinder, allow
Turn heater to control fully off position before removing and replace the cylinder
Do not attempt to remove the regulator while the heater is still running.
Do not move the heater while it is in use.
Always face the heater towards the centre of the room.
Use it only in a well-ventilated room. Ventilated is vital for the efficient
performance of this heater and for safety of the occupants of the room in which
it is being used.
Allow plenty of fresh air in, never seal up the doorways and windows.
Prevent young children and the infirm from touching very hot surfaces.
The normal dress guard only protects against accidental clothing contact.
Do not place clothes or other material on the heater.
Keep all flammable materials at least one meter away from the heater.
Turn off the gas valve and gas supply after use.
Never use or store solvents and pressure pack cans near a gas heater
even if the heater is turned off.
Never dispose of rubbish such as cigarette butts in a gas fire-this can affect
Combustion and produce dangerous pollutants. and carbon monoxide
Always operate the gas control and cylinder valve from the side or rear
of the heater.
Standing in front of the heater exposes you to the risk of burns
This product is not intended for commercial use
This product is not intended to be operated by children or the infirm unless
adequate supervision and/or training has been given by the responsible person.
IIn the event of a gas leak open all doors and windows and do not use electrical
equipment as these may produce a spark which could ignight the LPG vapours
Lighting the Heater:
Before connecting the regulator to the gas cylinder. Cheek whether there
is a rubber washer on the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise.
Turn the gas control knob on the heater to setting 1(fig 4).
Press the control knob down and hold in the pressed condition. This will allow
gas to flow to the pilot and center burner.
While holding the control knob in the pressed position push the piezo electric
ignition (fig 4) button 2 or 3 tines. Each tine you strike this piezoelectric ignition
you will hear a clicking sound as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed
position for a further 10 to 15 seconds thus activating the flame failure safety
device.
The pilot and center burner should remain alight.
You may now adjust the heater setting to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position 1 and close the gas
cylinder valve by turning the knob on the cylinder clockwise. Ensure that the
pilot flame the center burner are extinguished.
Heat and ignition controls
Piezo Quartz Ignition Button
MAX HEAT
MIN HEAT MED HEAT
Installation
Put the cylinder into the gas heater then install the protection baffle to make
sure the cylinder cant' move when the fire is moved from room to room
connect the pipe to the gas valve with cap (make sure no leakage)
Connect another side of the pipe to the regulator with cap (make sure no leakage)
Open the gas valve before using the heater, and close the gas valve after using.
WL39002 -manual -1.indd 6-7
13/10/2011 09:38:56
