Warming-Trends.com | 303 346 2224 | [email protected]
14
FK2 Installation:
6.6
Identify your FK2 for 300K BTU and above units.
{See Photo 24}
6.7
Identify one of the ¾” x 3” nipples that comes with your kit. Apply thread sealant to one end of the nipple
and screw into the “IN” side of the valve. Tighten leaks
{See Photo 25}
6.8
Your FK2 kit should have two flex lines. Each flex line comes with two flared fittings screwed onto the end.
Remove these from the flex line. Identify the 3/4” tee that comes with your kit. Screw this onto the end of the
3/4” x 3” nipple attached to the valve. Then, screw the non-flared ends of two of the flared fittings into the
tee. Use thread sealant for all connections and tighten all connections with a wrench to avoid leaks.
{See
Photo 26}
for complete installation.
Photo 24: FK2
Photo 25: Connecting the ¾” x 3” nipple to the Platinum Valve
Photo 26: Connecting the Flared Fittings and ¾” Tee to the 3” Nipple
Flex Line
Flared Fitting
3” Key
12” Key
3/4” Key Valve
3/4” x 1/2” Adapter
Escutcheon Plate
3/4” Tee
3/4” x 3” Nipple
Flared End (No thread sealant)
Tapered End (Apply thread sealant)
