Waring WFP14SK, Руководство пользователя

Страница: 8 / 64

ASSEMBLY OF BATCH BOWL PARTS
We will use the terms bowl, work bowl and batch bowl
interchangeably throughout this instruction book. They mean the
same thing.
• Clean and sanitize the motor base, and wash, rinse, and sanitize
the bowl, cover, food pusher, food pusher insert and processing
tools prior to initial use.
• Place the base on a counter or table near an outlet. Position it so
you look at the front of the unit and can see the control levers. Be
certain that the cord is unplugged and the OFF ( ) lever has been
pressed. Do not plug in the cord until the processor is completely
assembled.
• Pick up the transparent work bowl, holding it in both hands with the
handle toward you.
• Place the bowl on the base, fitting its central tube over the motor
shaft on the base and placing its handle slightly to the left of front-
center (at about a 7 o’clock position).
• Press the bowl down so the lower rim fits around the circular
platform. Turn the bowl counterclockwise as far as it will go. It will
lock into position with the tabs on the sides of the platform.
Read this if assembling the batch bowl parts to use S-blade
(cutter blade).
• Pick up the metal blade, noting the diagram on the top of the plastic
center. It matches the shape of the motor shaft.
• Place the S-blade over the tip of the motor shaft, lining up the
inside of the hub with the shaft. Press it down firmly, rotating the
center hub until the blade assembly is fully seated. It should easily
drop into place. Push firmly to lock and seal S-blade hub in place.
Be sure it is pushed down as far as it will go. If it is not all the way
down, it may become damaged and any liquid may leak. Push only
on the center section (plastic part); never touch the cutting blade as
it is extremely sharp.
• Check to be sure the blade is all the way down by turning it back
and forth while lightly pushing it down. If properly installed and
fully seated, the lower blade will be positioned just above the inside
bottom of the bowl.
• If processing food with the S-blade, now is the time to add the food
or liquid to the work bowl.
• Always process dry food first, then add wet food.
8