HAWK-800 Constructions and Installations Instructions –
Step 3 – Install the Capacitors and Resistors into the HAWK-800 Board
●
Install the four capacitors and two 10K ohm resistors on the top side of the HAWK board. The location of the
capacitors varies slightly with the different version of the HAWK-800 board. Version 1.5c boards have a top silk
screen that clearly shows the locations of each of the resistors and capacitors.
●
Use the picture below that corresponds to the board version that you have.
●
The first picture applies to the version 1.5 board. “V1.5” is found in the upper right corner of the board.
●
The second picture applies to the version 1.5b board. “V1.5b” is found in the bottom right hand corner of the
board.
●
The third picture applies to the version 1.5c board. “V1.5c” is found in the bottom right hand corner of the board.
6 Of 29
