HAWK-800 Constructions and Installations Instructions –
Step 24 - Mounting the HAWK board in an original Poly 800
●
Attach four printed circuit board standoffs (not supplied) to the printed circuit board with four screws (not
supplied). We used standoffs 1/4 inch high with tapped brass inserts.
●
Using a suitable non damaging cleaner, thoroughly clean the area in the Poly 800 case where the board is to be
mounted.
●
Using either a hot melt glue gun or another suitable epoxy or silicon based glue, attach the board to the case.
●
Take care that you position the board so that it will not interfere with the metal case mounting brackets and
screws (see the picture below). Line up the top edge of the HAWK-800 board with the plastic rib that runs
horizontally and align the left and right with the ribs as shown in the picture.
●
Allow plenty of time for the glue to dry/cure before attempting to unscrew the mounting screws. You shouldn't
actually have to remove the board unless it doesn't work for some reason.
Step 25 – Install the 28 pin and 16 pin header cables
●
Locate and install the 28 pin header cable assembly. Be careful to ensure that the pins are lined up correctly with
the sockets because it is very easy to incorrectly align the plugs in these sockets. Also take great care to ensure
20 Of 29
