HAWK-800 Constructions and Installations Instructions –
Step 14 – Remove Three Chips from the Effects Board
●
Remove the EPROM chip (IC24) from the 28 pin socket on the effects board. Use a pair of tweezers or a small
screwdriver to remove the chip. The ROM is not needed once the HAWK-800 is installed but you should store the
EPROM in a safe place so that it can be used again if needed.
●
De-solder and remove IC22 and IC23 from the effects board. Use the picture below as a guide.
●
Ensure that you clean up any loose solder from the effects board so that it is clean and thus, reliable.
Step 15 – Install the Effects Board Jumper
●
Now install a jumper onto the back of the effects board as shown in the picture below. Be particularly certain that
you are connecting the jumper to the correct points as shown in the picture and ensure that the jumper reliably
connects the two pins together (one of which is a through hole connection) and that the jumper wire does not
short out to any other traces or pins on the board.
●
This jumper is critical for the correct operation of the MK2 effects board. So if you later discover that your effects
are not working as expected then double check this jumper location.
13 Of 29
