Installation
6.
On the left side, insert the black connector marked ‘D’ into the Z
axis end stop switch marked ‘D’.
7.
Remove the outer plastic nut from the Filament Spool Holder, then
insert the threaded end into the large hole of the Filament Spool
Holder Stand. Tighten the plastic nuts on each side to secure
8.
Position the Filament Spool Holder Stand on top of the Extruder
Tower, with the Filament Spool Holder centred on the stand. Insert
two bolts and tighten with the hex wrench until secure
9.
Ensure the power switch is in the OFF position, then insert the Power
Supply Cable into the back of the Control Box. Insert the other end
into a nearby mains power outlet. Turn on the power outlet, then turn
ton the 3D Printer, using the switch on the back of the Control Box
10.
Wait for the printer to initialise, with ‘Printer Ready’ shown at the
bottom of the LCD. You’ve successfully setup your WANHAO 3D
Printer
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator I3 V2
22
