Installation
1.4 Unboxing and Assembly
Your WANHAO 3D Printer is packed tightly and carefully -- take your time unpacking it.
To view a step by step video of the Unboxing and Assembly, visit
www.wanhao3dprinter.com/Video/i3 video/wanhao i3 unboxing
1.
Place the Control Box, Extruder Tower and Heated Print Bed on a
clean, level work space. Carefully remove the cable tie that holds
the Extruder in place
2.
Insert the Heated Print Bed lengthways between the legs of the
Extruder Tower and align the bolt holes on each side. Using the Hex
Wrench, insert and tighten the two external bolts. Place printer on its
side, then insert and tighten the two internal bolts
3.
Ctarefully cut the cable tie on the left side of the Heated Print Bed.
Then, on the left side, insert the short cable connector marked ‘A’ into
the motor connector of the Extruder Tower marked ‘A’
4.
On the left side, insert the long cable connector marked ‘B’ into the
motor connector of the Extruder Tower marked ‘B’
5.
On the left side, insert the white connector marked ‘C’ into the black
connector of the Extruder Tower marked ‘C’
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator I3 V2
21
