WANHAO DUPLICATOR 9, Инструкция по эксплуатации

Страница: 29 / 58

Setup
3.3 Removing Filament:
1. With the printer initialised, press the Navigation Dial to enter the menu system.
2. Navigate to, and select Tool > Preheat PLA or Preheat ABS depending on the
material.
3. Check the temperature of the Extruder and plate on the LCD. When the temperatures are
within a few degrees of the target, you are ready to remove the filament.
NOTE: Preheat PLA/Preheat ABS will still be shown, even after temperatures have been reached.
4. Depress the Extruder spring lever. Push down on the filament gently so that it starts to
extrude from the nozzle.
5. When filament is extruding, quickly, but gently pull the filament upward. If it is done correctly,
the end of the filament will pull out into a thin hair like strand.
NOTE: The aim is to sever the filament where is it soft (inside the nozzle). Swift upward action will
ensure that the filament does not cool down before exiting the nozzle inlet. If the filament gets
stuck, please see the troubleshooting section.
3.4 Storage:
Both PLA and ABS filaments are sensitive to moisture. If stored in a humid environment, the quality
of the filament can deteriorate, with a tendency to bubble and spurt from the nozzle tip. This will
affect print quality, so when storing PLA or ABS for an extended period of time, follow these tips.
• Store in a sealed, air tight bag/container. We recommend a vacuum seal bag
• Store with a silica gel (moisture absorber) pack. One is included with each filament spool
4. Using the SD Card
4.1 Loading files from your Computer:
1. Insert your SD Card into a card reader or memory card slot and connect to your
computer (refer to your computer manual for further instructions if required).
2. The Micro SD Card will appear as a folder (refer to your computer manual for further
instructions if required).
3. Copy your converted GCODE files to the SD card, then safely remove.
29
AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator 9