WANHAO Duplicator 10, Инструкция по эксплуатации

Страница: 18 / 37

CUSTOMER SUPPORT
+86-571-23290996 support@wanhao3dprinter.com Model: Duplicator 10
DOWNLOADING
AND INSTALLING CURA
The preferred software for your printer is Cura .
This software package prepares your 3D model into instructions that
your printer uses to produce an object.
1. The Cura software package can be downloaded
from the “ Down Load Software ” section on our website:
http://www.wanhao3dprinter.com/Down/ShowArticle.
asp?ArticleID=56
2. Download the latest version of Cura for your operating system. Our software is
available for, WindowsXP or newer, MacOS 10.6 or newer and Ubuntu Linux 12.10
or newer.
3. Open the installer and follow the directions to install the software.
4. After installing Cura, Cura will ask
what kind of 3D printer you have.
Select the D10 . No other
configuration will be required, and
Cura will be ready to use.
5. After the installation you will see the
D10-robot positioned in the Cura interface.
In case you did not select the machine
type. Please go to Machine—Wanhao-D10
to select the correct machine.
6. If you already have this software, then you just need to add the D10 into the setting, Detailed
tutorial is on page 25.
NOTE: We keep on updating our software, so the
latest version that you have downloaded might be a
newer version than the one in this manual.
17