W&T Microwall Gigabit 55210, Руководство пользователя

Страница: 11 / 75

11
W&T
Subject to error and alteration
tance of 10-15 cm between the Microwall and nearby heat
sources must be maintained.
Input voltage and output currents must not exceed the rated
values in the specification.
When installing be sure that no stray wires stick out through
the ventilation slit of the Microwall into the housing. Ensure
that no individual wires stand off from leads, that the lead is
fully contained in the clamp and that the screws are tightly
fastened. Fully tighten screws on unused terminals.
The power supply used for the Microwall must absolutely
ensure safe isolation of the low-voltage side from the
supply mains according to EN62368-1 and must have “LPS“
designation.
EMV
1
NOTE
Only shielded network cables may be used for connecting the
Microwall to the network.
In this case the Microwall meet the noise immunity limits for
industrial applications and the stricter emissions limits for
households and small businesses. Therefore there are no
EMC-related limitations with respect to the usability of the
devices in such environments.
The complete Declarations of Conformity for the devices
described in the manual can be found on the corresponding
Internet page at the W&T homepage: http://www.wut.de.