WANDERS SOLEA GAS, Руководство пользователя и инструкция по установке

Страница: 23 / 70

23
GB
can preset the desired temperature by the half degree
with the big buttons
T
and
U
. The remote control will
automatically switch back to day-temperature setting.
The minimum day temperature is 5 degrees Celsius.
7
- temp
Briefly press the ‘SET’ button twice and the
7
-temp
will appear on the display. When you press and hold
the ‘SET’ button, the night-temperature indication will
start flashing. You can preset the desired temperature
by the half degree with the big buttons
T
and
U
. The
remote control will automatically switch back to night-
temperature setting. The minimum night temperature is
0 degrees Celsius. The display will then show the ‘- -‘
signal.
TIMER
You can preset a total of four time-settings. When you link
up all four time-settings, comfortable room temperatures
are ensured at all times.
Press ‘SET’ three times and the word ‘TIMER’ appears
on the lower right hand side of the display. Keep the
‘SET’ button pressed until the signal P1
C
appears and
the time indication is blinking. With the buttons
T
and
U
you can set respectively the hours and the minutes.
By briefly pressing the ‘SET’ button you can browse
through the timer programme P1
C
-temp, P1
7
-temp,
P2
C
-temp, P2
7
-temp. Here is an example of a possible
presetting.
P1
C
-temp: 07:30 - 08:30 19º C
P1
7
-temp: 08:30 - 17:00 15º C
P2
C
-temp: 17:00 - 23:00 19º C
P2
7
-temp: 23:00 - 07:30 15º C
The TIMER function works only when the pilot flame is
on. Press ‘OFF’ once to switch off the TIMER function.
The remote control will automatically switch to the
MAN position.
Thermostat
The remote control handset is also the thermostat of your
gas fireplace. With the symbols
C
-temp and
7
-temp
you can preset the day and night temperatures. For the
optimum effect we advise you to use the handset remote
within a five-metre range, with the display pointed
directly at the fireplace.
Lighting the fire manually
Your Solea gas fireplace can also be ignited manually.
Please follow the instructions given below.
1. Open the door of the fireplace as shown on page 20.
Remove also the frontplate of the base.
2. Disconnect the ignition cable from the receiver and
connect it to the ignition block.
3. Turn the ‘0 I’ switch to the ‘I’ position. Turn the
motor switch all the way to the right until you hear a
ticking sound. Switch the operating switch to ‘MAN’
position.
4. Push a pen through the big hole against the small
metal bar and keep it pressed in. Press the small
square cube in the orifice.
5. You will now hear a ticking sound and the pilot flame
will ignite. When the pilot flame is burning, keep
pressing against the small metal bar for about 10
seconds.