WamBlee W440, Инструкция по эксплуатации

Страница: 12 / 16

How to 'arm' your W440
To ensure that your W440 is ready to receive any alarm you must proceed
as follows:
1. Move the knob switch to position B.
2. A beep of 1 second and the green LED will indicate the correct
power on sequence.
3. The red LED on your device will begin to flash indicating that
W440 is in the process of recognition of the serial communication.
the AIS receiving device must be turned on, working and able to
receive AIS signals.
4. Wait that the device completes the procedure described in item 3.
The turning off of the red LED and the turning on of the light on
the switch indicate the successful startup.
5. Your W440 unit is now ready to receive alarms.
Activation following MOB alert message
If an AIS MOB or SART unit able to send a message like 'MOB ACTIVE' or
'SART ACTIVE' is activated in range of your radio equipment, the W440
unit will recognize the NMEA sentence and behave differently depending
on the DIP Switch 1 condition.
DIP Switch 1 Action
Open
If the ID code is present among those stored, the relay
contact to the upper connector, position 8 and 7, will move
from open to closed. At the same time the lamp in the
know switch flashing at 1 second/rate , accompanied by 2
beeps of the buzzer, red and green LEDs will remain on.
Close (or ON)
If the DIP switch 1 is closed and if the received ID code
starts with 970 or 972, the relay contact to the upper
connector, position 8 and 7, will move from open to closed.
At the same time the lamp in the know switch flashing at 1
second/rate , accompanied by 2 beeps of the buzzer, red
and green LEDs will remain on.
12
EN