WamBlee W440, Инструкция по эксплуатации

Страница: 10 / 16

Using the W440 and its programming.
The W440 control is made through the use of a three-position switch (2
fixed and one spring return).
Through the switch you can control the operation of your W440 unit, which
will operate in this way:
•
Position (A) = disabled.
•
Position (B) = active device and armed
•
Position (C) = selection mode and reset (with spring return to
position B).
The W440 unit is also equipped with two DIP switches located to the left of
the lower connector (4). Their function is the following:
DIP Switch Open Close (On position)
1 The alarm is activated only if
the AIS ID recognized code is
one of the 8 previously ID
programmed in memory .
(below the procedure for
programming is described).
The alarm is activated if the AIS
received message contains an
ID that starts with 970 or 972,
regardless of the rest of the
code.
2 Set the line to be used with a
piezo buzzer .
Set the line to be used with a
ON / OFF buzzer (bell or buzzer).
10
EN