WamBlee W440, Инструкция по эксплуатации

Страница: 11 / 16

How to store the MSLD MOB ID
The W440 AIS Sart Sniffer lets you store up to 8 AIS SART codes, so that
the alarm is activated only for codes stored (unless this feature is disabled,
see the dip switch setting).
To store a code (or overwrite), proceed as follows:
1. Move the knob selector in position C and keep it pressed for 5
seconds.
2. The lamp switch will begin to flash at a rate of 1 flash per second;
each flash indicates the memory position currently in use (1 flash
= position 1, position 2 = 2 flashes, etc.).
3. To change the memory location simply release the switch to its
central location for a couple of seconds and repeat the procedure
from step 1. The new location will be the next to the previous one.
4. Release the switch back to position B. The luminous body of the
switch will continue to flash indicating the selected memory
location.
5. Turn on a AIS SART device nearby, make sure the device is
activated in MOB TEST mode and IT makes a test transmission
(check the instructions in the manual of the manufacturer of the
MOB equipment).
6. After a successful transmission and subsequent reception of AIS
message, the W440 will indicate acceptance of the new ID code
with light on (no flashing) and audible beep by a duration of 2
seconds.
7. The W440 has stored the new code in the AIS position required
and your unit is back to the operating mode.
11
EN