Waltron daytime matrix module WW, Руководство по эксплуатации

Страница: 18 / 21

5.4 Adjusting and attaching the Inline adapter system
NOTICE! During the setup and initial usage, make sure that there is at least a 15-mm gap
between the bottom of the lamp and the water surface.
The matrix includes the Inline adapter system
(four adapter rods in the non-slip profile).
In their delivered state, these are already
attached with screws so that they are flush with
the lamp ends.
The rods can be moved by loosening (¼-
turn)* the screws.
You can use the special key tool to remove
the rods.
* Do not loosen the screws more than a ¼ turn,
so that the adapter rods always remain in their
correct positions.
The adapter rods are graduated at one side
and have a rubber bumper. These can be used
for support (e.g. directly at the tank edge or on
one partition of the cover).
After adjusting to fit the tank width, tighten
the screws gently a bit so that the rods are
secured in place.
There is a metric-threaded hole (size: M3) on
the opposite side that can be used to attach
various adapter sets (refer to the the Available
Accessories chapter).
The Inline adapter system allows two matrix
lights to be connected at the front side.
1. Push the adapter rods halfway out of
one lamp and secure in place. Remove
the rods from the second lamp.
2. Put them together and secure in place.
NOTICE! We recommend using the cord
suspension or a middle support (e.g. glass
partition) when using this connection; this will
avoid any bending that could be visually
disturbing.
1/4