5.2 Mounting the matrix LED modules
NOTICE!
Carefully read the following description of the module's placement and attachment.
Carry out the steps described in the order listed.
The correct polarity must be observed (also refer to the mounting instructions enclosed
with the modules)!
The modules are inserted into the lamp profile by hand without extra equipment.
Use only the special key tool (included with the matrix) when attaching or removing the modules of
the Inline adapter system.
Verify that that module sets are complete:
1 pc. matrix LED module
4 pcs. cylinder head screws M4x8 (V4A)
1 pc. installation instructions
Depending on the version, the modules can
have from 2 to 4 contact pins (on the bottom).
All pins must be fitted with a seal.
Modules
with damaged or missing seal gaskets must
not be used.
Checking the inside of the lamp profile; remove
any residues from previous usage and clean
the inside.
For optimal heat dissipation, the partitions, in
particular, must be free of residues or other
foreign contaminants.
Select the module position and insert (but do
not press in yet) the module.
Make sure the
polarity is properly aligned:
1
to
1 / 2
to
2 / 3
to
3
/
+
to
+
(Refer to the label on the module and the lamp
profile.)
Remove the modules in order to change their
positions. Do not move any installed modules
within the lamp profile (the contacts must not
be "scraped").
Содержание daytime matrix module WW
Страница 1: ...Operating Manual...
Страница 12: ...4 Overview and explanations of lamps...
