Walther prazision 91489, Руководство по эксплуатации

Страница: 174 / 191

Working instruction
english
typ 91489
Appendix:
Description of extra equipment
174
Installation of voltage supply plug
Drawing 1-95288-4/1-XX001-Y02/3
Connection screwed cable gland
M 16x1,5,
Cable diameter 4,5 – 10
Installation sequence
a) Disassembly/assembly see 7.4(disassembly of fluid elements).
b) Slide electro plug/electro socket sideways out of the guide.
c) Unscrew the 4 cover screws with screwdriver for hexagon socket SW 3.
Caution
Screws are not secured against falling out.
d) Remove distance sleeve.
e) Linearly pull out socket/plug insert (insulating body).
f) Dismantle line and strip the insulation of the single conductors, both according
to dimension.
g) Lead electro cable through screwed cable gland.
h) Crimp (4 point crimping) single conductor to contact socket/contact pin.
Strands must be visible in window after crimping.
i) Absolutely avoid solder beads at the outside of the contacts when soldering.
j) Pre-plug contact sockets into the rear of the socket insert ( contact pins in pin insert),
row for row.Blind bores must be sealed with blanking plugs.
Caution!
Please observe position of the earth contact!
k) Linearly slide in contact sockets/ contact pins with a WALTHER assembly tool
(inserting tool) until they snap in – row for row.
l) Check the perfect snap in by a slight pulling at the single conductors.
m) Disassemble the contact sockets/ contact pins by means of a suitable
disassembly tool – squeeze out from plug side.
n) Linearly insert ready made socket/pin insert into socket/pin insert holder.
o) Insert cover seal and crosswise fasten cover with 4 screws with screw driver SW 3.
Prior to screwing provide screws with screw safety LOCTITE 243.
p) Tighten screwed cable gland.
q) Push electro plug/electro socket sideways into the guide.
r) Further assembly in reverse order as described under A).