Walther prazision 91489, Руководство по эксплуатации

Страница: 175 / 191

Working instruction
english
typ 91489
Appendix:
Description of extra equipment
175
Installation of signal plug
Drawing 1-95288-4/1-XX002-Y02
Connection flanged male socket/pins
Installation sequence
a) Aus-/Einbau siehe 7.4 (Ausbau der Fluid-Elemente).
b) Slide electro plug/electro socket sideways out of the guide
c) Unscrew the 4 cover screws with screwdriver for hexagon socket SW 3.
d) Unscrew the 2 screws of the flanged male socket/pins with screwdriver.
e) Remove distance sleeve.
f) Linearly pull out socket insert/plug insert (insulating body).
g) Strip the insulation of the necessary conductors..
h) Crimp (4 point crimping) conductor to contact socket/contact pins of the
flanged male socket/flanged male pins.
i) Linearly slide in contact sockets/contact pins with a WALTHER assembly tool inserting
tool) until they snap in – row for row.
j) Check the perfect snap in by a slight pulling at the single conductors.
k) Disassemble the contact sockets/ contact pins by means of a suitable
disassembly tool – squeeze out from plug side.
l) Cut conductor into required length and strip the insulation.
m) Crimp (4 point crimping) single conductor to contact socket/contact pin. Strands
must be visible in window after crimping.
n) Pre-plug contact sockets into the rear of the socket insert ( contact pins in pin insert),
row for row.
Blind bores must be sealed withblanking plugs.
Caution!
Please observe position of the earth contact!
o) Linearly slide in contact sockets/ contact pins with a WALTHER assembly tool
(inserting tool) until they snap in – row for row.
p) Check the perfect snap in by a slight pulling at the single conductors.
q) Disassemble the contact sockets/ contact pins by means of a suitable disassembly
tool – squeeze out from plug side.
r) Linearly insert ready made socket/pin insert into socket/pin insert holder.
s) Insert cover seal and crosswise fasten cover with 4 screws with a screwdriver.
t) Fasten screws of the flanged male socket/pins with a screwdriver.
u) Push electo plug/electro socket sideways into the guide.
v) Further assembly in reverse order as described under A)