Walter 39-D 252, Руководство пользователя

Страница: 7 / 72

7
4) SPECIFICATIONS
Maximum hole cutting capacity in mild steel (Ø X DoC) = 2- 3/8” x 3”
(3” DoC requir es 2-piece pilot pin 05-Z 032)
Arbor bore = MT2
Motor Unit
Voltage 120V 50-60Hz
Normal full load 14A
Electro Magnet 0.53A
Size 200mm long
98mm wide
Holding Force at 20°C with 25mm minimum plate thickness
The use on any material less than 25mm thick will progressively reduce the
magnetic performance. If possible, substitute material should be
positioned under the magnet and work piece to equate to a suitable
material thickness. If this is not possible, an alternative secure method of
restraining the machine must be used.
1378kgs
Total Load ( motor) 14.53 amps
Overall Dimensions
Height - maximum extended 586mm
Height - minimum 450mm
Width (including capstan fitting) 255mm
Length Overall (including guard) 395mm
Net Weight 18.5Kg
Product Code Icecut 250 Auto (39-D 252)
Suitable only for a single phase 50-60Hz A.C. power supply
DO NOT USE ON D.C. SUPPLY
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will earth back through the magnet and cause irreparable damage.
WARNING: THIS APPLIANCE MUST BE EARTHED!
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE GUARANTEE
5) OPERATIONAL SAFETY PROCEDURES
READ BEFORE USING THE MACHINE
•
When using electrical tools, basic safety precautions should always be followed to reduce the risk of
electric shock, fire and personal injury.
•
Ensure the magnet is off before plugging in the machine.
•
Do not use in wet or damp conditions. Failure to do so may result in personal injury.
•
Do not use in the presence of flammable liquids, gases or in high risk environments. Failure to do so
may result in personal injury.
•
Before activating the machine, inspect all electrical supply cables (including extension leads) and
replace if damaged. Do not use if there are any signs of damage.
•
Only use extension cables approved for site conditions.