Chapter 4
Liftgate
Installation
Protect wires from any sharp edges or
holes that may abrade insulated covering
of wires.
Secure battery cable so it does not come
near, or in contact with, other vehicle
wiring, fuel lines, brake lines, air hoses,
exhaust system, etc.
IMPORTANT:
DO NOT operate liftgate until Mounting Bar has
been removed.
GR00080
2
1
INSTALLATION OF POWER CABLE
Locate and mount 150 Amp circuit breaker directly to
batteries using copper terminal link supplied.
Circuit breaker must be mounted to give good protection
against any objects coming into contact with circuit
breaker terminals and causing a short. Position must
also be readily accessible to reset breaker.
NOTE:
Circuit Breaker is to rest solidly on battery
to prevent vibration during transit.
If unable to connect circuit breaker direct to batteries,
an optional 24”, maximum length, 2 Ga. battery cable
may be used.
Connect red positive 2GA cable to red quick connector
behind main frame.
Connect black negative 2GA cable to black quick
connector behind main frame.
Route power and ground cables along truck chassis,
towards truck batteries, securing them every 24” with
cable ties provided.
Do not connect any cables to batteries at this time.
