Installation
26
4.4
Angle sensor for autotilt
On tail lifts without pre installed platform, install the angle sensor. The angle sensor is connected but not
secured to the platform when delivered.
1.
When installing the angle sensor on the platform, use the rivets supplied.
2. Secure the sensor cable with cable ties.
IMPORTANT!
Route the cable between the platform and the lift arm tube such that it is well protected when the plat-
form touches the ground.
Leave enough slack to the first cable tie to avoid the risk of damage to the cable during lift operation.
The autotilt angle can be adjusted, see section "7.7 Adjusting the autotilt angle" on page 30
Picture 19. Installing the angle sensor
