wallhugger S-cape 2MR, Руководство по эксплуатации

Страница: 6 / 12

S-Cape
™
2MR Hand Control Operation Guide 99300906
The two step procedure below is required to program 1 hand control to operate 1 bed. Before
beginning, make certain the bed is plugged into a working grounded electrical outlet.
If
programming fails, initiate the programming procedure a second time.
S-CAPE ™ 2MR PROGRAMMING 1 hand control - 1 bed
STEP 1
The bed will be equipped with either a
power down box or J box receiver unit
( FIGURE 2 ). Locate the receiver unit for the
bed and press the learn button for 1 second
and release. Note: If you experience
difficulty locating or reaching the learn
button on a J box equipped adjustable bed,
refer to
J Box Programming on page 5.
STEP 2
On the hand control, simultaneously press
and hold the
POS 1 and head massage
on/off buttons ( FIGURE 3 ). The
transmission indicator light will flash
slowly and then flash rapidly to indicate
programming mode. Continue to hold for 5
seconds and then release the buttons.
One hand control is now programmed to
operate one bed.
POS 1
BUTTON
TRANSMISSION
INDICATOR
LIGHT
FIGURE 3
HEAD MASSAGE
ON/OFF
BUTTON
J BOX
FIGURE 2: Power down box and J box receiver units.
LEARN
BUTTON
LEARN
BUTTON
POWER
DOWN BOX
POWER DOWN
BOX RECEIVER
UNIT IS NOT
MOUNTED TO
BED FRAME.
J BOX RECEIVER
UNIT IS MOUNTED
TO THE BOTTOM
SIDE OF THE
BED FRAME.
6