Revision 12
10
Product Manual Solid Surface WC Pans
2. The CWC models that include a separate rear extension (i.e.; CWC-81-EXT) that
is clamped between the WC pan & the wall, are provided with longer length wall
fixing threaded M10 studs.
3. The CWC models that include a fixed rear shroud (i.e. CWC-155) are fitted with 4
x M10 bolts (inside the rear shroud section) fastened into the rear of the WC pan;
there are two upper and two lower bolts. The two lower bolts need to be removed
(viewed with the WC pan standing the correct way up) to fit the lower wall fixing
studs.
4. Fit the wall fixings (M10 studs) into the threaded inserts on the back of the WC
pan.
5. If model of pan or pan extension has floor fixings, position the pan & extension
into place against the wall and mark the position of the floor fixing holes. Remove
the pan and then drill the floor to fit the Rawl plugs supplied with the fixing kit.
NOTE: Do not drill into the floor through the holes in the WC pan or extension
as there is a risk that it may result in damage to the products.
6. Fit the flush pipe seal provided with the flushing device into the top hole on the
back of the WC pan.
7. Locate the CWC outlet spigot into the soil pipe connector and position the WC
into place (with the extension if applicable).
8. Assemble the wall bracket nuts and washers onto the M10 wall studs. Check that
the back of the wc pan has fitted to the wall without any gaps due to an uneven
wall finish prior to tightening each fixing to a torque of 17Nm. Gradually tighten all
fixing nuts evenly in a rotational method so each one gradually tightens to the
stated torque.
NOTE: The wall fixing threaded studs can be cut down in length if required
should they protrude through the wall excessively.
9. Tighten the floor fixings (if used) ensuring that they are not overtightened as that
may result in damage to the pan, the recommended max torque is 6Nm. It is vital
that the floor surface is level as an uneven floor surface may also result in
damage to the pan when the fixings are tightened. Fit the floor fixing screw
covers.
WARNING! Fitting the water closet to an uneven floor surface or overtightening
the floor fixings may result in damage to the product.
10. Apply an anti-pick, hard set mastic, such as Arbokol 1025 or Sikadur 33 around
the back and bottom edges of the pan (& extension if appropriate) to seal it to the
wall & floor.
