Wallenstein BXT52S, Руководство оператора

Страница: 34 / 76

6.6 Start the Machine
WARNING!
Before you start the machine, read and
understand all of the safety information in this
manual and the engine manufacturer's manual.
W118
IMPORTANT! Use short starting cycles (maximum five
seconds) and wait one minute between cycles. If the engine
does not start after repeated attempts, contact your local
dealer or go to
VanguardPower.com .
Before you start the machine, see the information under
Controls on page 22 and Engine Operation Safety on page
30 .
1. Complete the tasks described in the Pre-Start Checklist on
page 29 .
2. Set up the machine.
For instructions, see
Set Up the Machine on page 35 .
3. Move the throttle control to the FAST position.
4. Insert the key, and then turn the ignition switch clockwise
to the
START position. When the engine starts or after five
seconds, release the key.
The ignition switch automatically turns counterclockwise to
the
RUN position.
5. Do one of the following:
• If the engine starts, continue with step 6.
• If the engine does not start, wait a minimum of one
minute, and then return to step 4.
6. Wait a minimum of three minutes for the rotor speed to
increase.
6.7 Stop the Machine
1. Stop putting material into the machine.
2. Wait for a minimum of 30 seconds to let all the material
blow out of the machine.
Material in the rotor housing can cause the engine to stall
the next time you start the machine.
3. Move the throttle control to the SLOW position.
4. Wait a minimum of one minute for the engine to decrease
the rotor speed.
5. Turn the ignition switch to the STOP position.
6. Remove the key.
Keep the key away from unapproved users and children.
6.8 Emergency Stop
In an emergency:
1. Press the emergency stop button.
2. When it is safe to do so, turn the engine ignition switch to
the
STOP position.
3. Remove the key and keep it with you.
Do not let anyone start the machine until the emergency is
resolved.
Operating Instructions
BXT52S
Wood Chipper
34