Wallenstein BXT52S, Руководство оператора

Страница: 35 / 76

6.9 Set Up the Machine
WARNING!
Always use the machine outdoors and park
the machine in a position where the prevailing
winds blow the engine exhaust away from the
operator. Exhaust from the engine contains
carbon monoxide (CO) that can accumulate to a
dangerous level, even in an area with good air
fl ow.
W006
For more information, see Figure 22 on page 36.
1. Select a work site and set up a safe work area.
For more information, see
Work Site on page 11.
2. Do one of the following:
• Disconnect the machine from the tow vehicle.
For instructions, see Disconnect from a Ball-Mount
Hitch on page 43 .
• If more stability is necessary, leave the machine
attached to the tow vehicle. Set the tow vehicle's
parking brake, stop the engine, and then remove the key
from the ignition.
3. Lower the trailer jack to support the machine in a level
position. The machine should be as level with the ground
as possible.
For instructions, see
Lower the Trailer Jack on page 44.
4. Move the chipper hopper to the open position.
For instructions, see
Open the Chipper Hopper on page
27.
5. Turn the discharge chute to direct the wood chips away
from the operator and in the direction of the wind.
For instructions, see
Discharge Chute on page 25.
6. Adjust the deflector to direct the wood chips further from or
closer to the machine.
For instructions, see
Deflector on page 25.
7. Make sure that the upper rotor housing is closed and the
fastener is tight.
8. Make sure that all of the guards and shields are installed
and the covers are closed.
9. Make sure that the emergency stop button is off .
If the emergency stop button is on (pressed), turn it
clockwise and pull.
For more information, see
Emergency Stop Button on page
22.
BXT52S
Wood Chipper
Operating Instructions
35