Operating Instructions
BX52R, BX72R, BX102R
Tractor Wood Chipper
44
7. Operating Instructions
WARNING!
Risk of serious injury or death. Keep hands, feet
and clothing away from feed rollers when the
chipper is operating. Do not climb onto the feed
table or hopper.
W023
WARNING!
Never reach into the feed hopper. There are
sharp knives that can trap, cut, and/or sever your
fi ngers or hand. Use a stick or branch to push
material that does not move into the machine.
If the machine is jammed, set the machine to a
safe condition, and then clear the jam.
W004
CAUTION!
Hearing loss hazard. Prolonged
exposure to loud noise may cause
permanent hearing loss. Use suitable
protection while operating the
machine.
W016
IMPORTANT! Do not put metal objects, bottles, cans, rocks,
glass or other foreign material into wood chipper. If such
items happen to get into the chipper, stop machine and turn
engine off. Wait for all moving parts to stop before removing
material. Inspect machine for damaged or loose parts
before resuming work.
IMPORTANT! Do not use PTO Cruise
Control with this wood chipper. The
chipper rotor slows and speeds up as
material is fed in. Cruise control then
attempts to adjust to changing flywheel
speeds. These fluctuations in engine
speed and torque can result in component
failure.
The operator has the responsibility of being familiar with and
following all operating and safety procedures.
Although this machine is easy to use, each operator should
review this section to get familiar with the detailed safety and
operating procedures.
7.1 Operating Safety Rules
• Do not reach into rotor or feed hopper openings when
the machine is running. Install and secure access covers
before starting engine.
• Do not move or transport chipper when the rotor is
turning.
• Keep hydraulic lines and fittings tight, in good condition
and free of leaks.
• Keep the working area clean and free of debris to prevent
tripping. Operate only on level ground.
• Do not point discharge at people, animals or buildings.
Rotor can expel wood chips fast enough to cause injury.
• Be aware of the size and shape of the material. Crotchety
branches and logs can move in unpredictable ways
as they pass through the feed rollers and could cause
injuries. Large curved pieces should be cut to smaller
straighter sections.
• Do not work alone, it is safer to work in pairs in case an
emergency arises.
• Never stand, sit, or climb onto any part of the chipper
while it is running.
• Place chipper in a Safe Condition before servicing,
adjusting, repairing, or unplugging.
• Always use the rotor lock to immobilize the rotor when
attempting to clear a clog or changing chipper blades.
See
.
• Do not run machine inside a closed building to prevent
asphyxiation from engine exhaust.
