Wallenstein 720123, Руководство оператора

Страница: 36 / 44

Service and Maintenance
WXR720/L, WXR740/L
Trailer Wood Splitter
36
required.
3. Apply a light coat of clean oil to the seal and install
the new filter. Tighten by hand only.
4. Run the machine for 1–2 minutes operating the
cylinder. Check filter head for oil leaks.
5. If a leak is found, shut off the machine and correct
it.
6.
Check hydraulic reservoir oil level. Top up as
required.
7. Dispose of spilled oil in an environmentally safe
manner.
8.7 Engine Air Cleaner
Check air filter every 50 hours of operation.
Change air filter elements at 100 hours of operation
or annually.
NOTE: Refer to the engine manual for information
on servicing the air cleaner.
A dirty air filter can restrict air flow to the carburetor,
reducing engine performance. If the engine is operated
in very dusty areas, clean the air filter more often than
specified
.
IMPORTANT! Operating the engine without an air
filter, or with a damaged air filter, can allow dirt to
enter the engine, causing rapid engine wear. This
type of damage is not covered by Warranty.
Inspection
Remove the air cleaner cover and inspect the filter
elements. Clean or replace dirty filter elements. Always
replace damaged filter elements.
8.8 Electrical System – General
(As equipped)
IMPORTANT! When assembling or replacing
wire harnesses, apply a thin coating of silicone
dielectric grease to the harness connectors.
Clean off any corrosion or loose particles, then
apply a small amount to the surfaces of the
connectors where they meet. The grease helps to
stop any possibility of future corrosion.
Reassemble the connection. If grease squeezes
out, wipe off with a rag or towel.