Wallenstein 720123, Руководство оператора

Страница: 22 / 44

Operating Instructions
WXR720/L, WXR740/L
Trailer Wood Splitter
22
5.2.1 STOP Position
• STOP is the valve’s neutral position. The wedge
or push block stop moving when the valve lever
is moved to this position. The valve lever spring-
returns to STOP when released from either extend
position, or auto-retract.
•
The valve lever can be moved to STOP at any
time.
5.2.2 High Speed Position (2)
• Pushing the lever forward to High Speed position
(2) at the first detent provides a higher cylinder
extension speed. In this position the cylinder
extends at high speed, but lower power.
• Releasing the lever returns it to STOP.
5.2.3 High Power Position (1)
•
Push the control lever fully forward to High Power
position (1) for maximum power. The cylinder
extends at a slower speed but provides higher
power to push the wedge or push block through
the wood for effective splitting.
• Releasing the lever returns it to STOP.
5.2.4 Retract Position
• Pull the lever fully backwards to retract the wedge
/ push block. The valve detent holds the lever in
retract allowing a hands-free return cycle.
• The valve lever returns to STOP (neutral) when
wedge / push block is fully retracted.
• The lever can be moved out of Retract into STOP
at any time.
6. Operating Instructions
Wallenstein WXR Trailer Wood Splitters are self-
contained machines designed to push wood through a
wedge to split it.
• The WXR720 splitter models operate in the
horizontal configuration only.
• The WXR740 splitter models can be used in the
vertical or horizontal configuration.
The operator has the responsibility of being
familiar with all operating and safety procedures
and following them.
6.1 Operating Safety
Read and obey the safety signs on the machine. Clean
or replace them if they are not legible.
There is no substitute for a cautious, safe-minded
operator who recognizes potential hazards and follows
reasonable safety practices. This machine must be
used with all its safety equipment properly installed to
minimize the chance of accidents.
1. Wear appropriate personal protective equipment.
Tie back long hair, remove jewelry, and avoid loose
fitting clothing. Prolonged exposure to loud noise
can cause permanent hearing loss! Wear hearing
protection on a full-time basis when using this
machine.
2. The operator must be in control of the machine at
all times. Read and understand owner's manual
before starting. Review safety instructions annually.
3. Never use engine-powered machinery indoors.
Gas engine exhaust contains toxic carbon
monoxide, which cannot be smelled or seen.
Breathing carbon monoxide can be lethal.
4. Make sure all guards, deflectors and shields are in
place before starting and operating.
5. Keep hands out of splitting area. Do not rest hands
on the log being split.
6.
Do not step over or straddle splitter during
operation.
7. Do not try to split more than one log at a time. The
logs can fly out and cause injury.
8. Keep your fingers and hands away from cracks in
the log that can open while splitting.
9.
Always load logs by grasping the bark side, not the
cut ends.
10. Do not reach into or load the splitter when the
wedge is in motion.