Wallbe LEO, Руководство по установке

Страница: 3 / 16

Driving eMobility 3/16
Installation Manual
1 GENERAL INFORMATION
1.1 Introduction
Thank you for choosing one of our products. The char-
ging stations of wallbe® offer convenient, safe and
standard compliant charging according to the standard
IEC 61851-1, charging mode 3.
Before putting the charging station into operation, read
the instruction manual carefully and follow the instruc-
tions.
Ensure that all persons working on or using this char-
ging system have read the operating manual, follow
the regulations and instructions for working without
risk.
Keep the equipment documentation at a location whe-
re it is always accessible to the operators of the char-
ging system.
Ensure that no unauthorized persons can access the
charging system.
1.2 Intended use
The charging system is intended for use in private and
semiprivate areas, e.g. private properties, corporate
parking areas, or depots.
Do not use the charging system where explosive or
combustible substances (e.g. gases, liquids, or dusts)
are stored or are present.
The charging system is intended exclusively for char-
ging electric vehicles.
• Charging in accordance with type 3 of IEC 61851-1
• Plug-and-socket connectors in accordance with
IEC 62196
• The charging system is intended for use only in TT,
TN-C, and TN-C-S networks. The charging system
must not be operated in IT networks.
The charging system is not suitable for charging vehic-
les with outgassing batteries (e.g. lead-acid batteries).
The charging system is operated as an individual sta-
tion without a superordinate control system. The char-
ging system is intended exclusively for stationary ins-
tallation.
The charging system may only be operated and used
by persons who have read the operating manual.
The electrical installation, start-up, and maintenan-
ce of the charging system may only be performed by
qualified electricians who have been correspondingly
authorized by the operator.
The qualified electricians must have read and unders-
tood the equipment documentation and must comply
with its instructions.
Requirements regarding the qualification of electrici
ans:
• Knowledge of and compliance with the 5 safety
rulesfor working with electrical installations:
- isolate.
- secure against reactivation.
- check absence of voltage.
- ground and short-circuit.
- cover or block off live parts in the vicinity.
Reactivation is carried out in reverse order.
• If further trades are required for assembly, the ne-
cessary activities may only be carried out by trained
specialists.
• No liability will be accepted for damage during trans-
port if the product is transported in anything other
than the original packaging.
• At all times, observe the local safety regulations for
the country in which you operate the device.
• Knowledge of the general and special safety regula-
tions and accident prevention regulations.
• Knowledge of the relevant electrotechnical regulati-
ons e.g. checks associated with commissioning and
the requirements for operating facilities, rooms, and
special types of equipment - power supply for elec-
tric vehicles.
• Ability to recognize risks and to avoid potential ha-
zards.
When installing and handling the charging system, the
user, the operator, and the electrician must comply
with the national regulations on safety and accident
prevention.