Wallbe LEO, Руководство по установке

Страница: 8 / 16

Driving eMobility 8/16
Installation Manual
• Disconnect the charging system from the power
supply by switching off the respective circuit brea-
ker in the building.
or
• Disable the charging system using the optional ex-
ternal blocking device.
Optional external blocking device
If an external blocking device (e.g. key switch) is con-
nected, the charging process is only started when the
Wallbox has been enabled by the external blocking de-
vice.
3 INSTALLATION
3.1 Prerequisites
• The Wallbox may only be operated when mounted
vertically.
• If possible, the Wallbox should be mounted so that
it is not directly exposed to rain e.g. to prevent icing,
being damaged by hail or similar. Do not expose the
Wallbox to direct sunlight because this can cause it
to overheat.
• The individual phases of the supply voltage must
each be protected with residual current devices and
circuit breakers.
• No single wires may be used for power supply.
• The diameter of the supply line must be between 9
mm and 17 mm.
• The charging current of the Wallbox must be set in
accordance with the building‘s circuit breakers. (The
procedure is described in the „Electrical connection“
section.)
3.2 Scope of supply/Enclosed accessories
• Mounting plate with electronics housing,
• Wallbox housing cover,
• 4x fillister head screws M4x10 (to attach the hou-
sing cover of the Wallbox),
• Cable gland ESKV25 (cable entry for power supply),
• Gasket EADR25, for cable gland ESKV25,
• Device documentation (safety instructions, installa-
tion
• instructions, operating manual).