wallas xs duo, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 43

Operation
en
First start-up
After installation or maintenance, if the fuel line is empty, the heater may not start
at the the first attempt. Start-up phase with empty fuel line is longer than normally
and might take about 15 minutes. If the heater doens’t ignite the red combustion
indicator light will start to blink after start-up.
Turn off the heater. The device cannot be restarted until the cooling phase is com-
pleted.
When the cooling phase is finished, switch the heater on again.
If the device does not start after two attempts, it cannot be started again: the heater
will lock itself (lights blink to indicate this). Find out the reason why the unit didn’t
start.
If the heater iginites during two attemps the red combustion indicator (1) will go on.
After locating the fault, release the locking (instructions in the maintenance section)
and start-up the unit.
Depending on the length of the fuel hose, the heater may have to be started up
several times during priming. Keep an eye on how the fuel travels in the fuel hose
while starting up the heater.
Run the device for c. 1-2 hour to allow possible installation and manufacturing
greases to burn off. Make sure there is enough ventilation.
Normal Use
The power is adjusted manually. The cooker will always ignite in manual mode.
After the ignition power can be adjusted step-less with the power control (2) knob.
Avoid turning the power control knob rapidly back and forth, this may cause the
burner to become sooty.
When using as a stove, make sure that the thermostat indicator light (5) is not on.
Cooker used as a heater, thermostat use
Requires a heat blower lid.
Automatic power adjustment, thermostat controlled adjustment.
Is used only with a heat blower lid when the lid is folded over the ceramic top.
The function can be activated/deactivated whenever wanted. Turn the power con-
trol knob (2) to positions min-max-min-max when yellow heating indicator (7) is on,
to activate the function. As a confirmation of the mode change, the thermostat light
(5) will be lit.
When turning again the power control knob (2) min-max-min-max, the thermostat
light (5) will go off and the unit returns to manual mode.
After the cooker has passed the ignition phase, the temperature is adjusted by
turning the power control knob (2). The power control knob is turned to the required
position.
When the thermostat light (5) is bright, the temperature is below the required tem -
perature – the effect is increased. When the thermostat light (5) dims the required
temperature is achieved.
D30101D
- 64 -
XC Duo
490541G