wallas Nautic 40D, Технические детали

Страница: 7 / 36

40D
7 / ENGLISH
490001
menu enter
Use on an Info Control Panel
The Info Control Panel is
equipped with a two-line
illuminated text display in
which the upper line
indicates the current menu
and the lower line suggests
a procedure. If no key is
pushed for 30 seconds, the
operating mode of the
device will be displayed.
When the heater is not on,
the display goes out after a
separately defined time.
Push any key to activate the
display.
The menu structure of the
Info Control Panel is shown
in table 2.
The main menu is used to
monitor the operation of the
heater and change settings.
Some of the main menu text,
e.g. “Reset error”, are only
displayed when they need to
be selected. The password
required for changing the
parameters is only given to
authorised Wallas repair
shops.
Heating
Select “Heating” under
Function in the main menu.
When in the heating mode,
press the ON/OFF key to
start the heater. The ignition
takes about 5 minutes after
which the basic display state
shows the Effect control as a
percentage (Direct control),
or the text “heating” and in
turn the set temperature of
the thermostat and the
measured temperature
(Thermostat control).
Use the arrow keys to
change the temperature and
effect setting. If you want to
set a new value as the
default, press finally Enter.
The heater will not
necessarily start at first after
the installation when the fuel
hose is empty. Then the
ignition stops at “Flame out”
error after start-up. The
heater cannot be restarted
until the cooling has been
completed. Reset the error
in the main menu and restart
the heater.
Press the ON/OFF key to
switch the heater off. The
cooling of the heater takes
about 10 minutes after
switch-off.
Figure 12:
Menu: Switches the display from function mode to the main menu and
back. Also acts as a cancel key in submenus.
Up and down arrows: Browse menus or adjust the value displayed on
the lower text line.
Enter: Resets the choice of a menu displayed on the lower line or a new
value.
ON/OFF: Switches the device on and off. The key is only active in
function mode.
Ventilation
Select “Ventilation” under
Function in the main menu.
When in the ventilation
mode, press the ON/OFF
key to start ventilation. Use
the arrow keys to adjust the
ventilation air flow. Press the
ON/OFF key to switch the
ventilation off.
USE