wallas 22 GB, Руководство пользователя

Страница: 59 / 325

K00120
en
Technical information
Operation description
The
22 GB, 30 GB
and
40 Dt
heaters are forced air diesel heaters without an ex -
posed flame.
The
22 GB
and
30 GB
models take combustion air from outside the boat through
the outer coaxial exhaust gas pipe and blow their exhaust out through the inner
coaxial pipe. The coaxial pipe connects to a common through hull fitting that
allows both inlet air and exhaust to pass separately. This process improves
efficiency, wind resistance and lowers the minimum power level. The model
40 Dt
takes combus- tion air from its place of installation and blows the exhaust gas out
through a single pipe.
For all these models, fresh makeup air is taken from desired areas with air intake
ducting, e.g. from outside of the boat or inside the cabin. This enables good air
circulation and cabin air replacement. Diesel engine compartment installations are
supported by the separate makeup air intake ducts, quarantining the makeup air
away rom any smells or noxious engine umes.
The heat generated by forced air fuel combustion, is transferred to the circulation
air by a heat exchanger. The heating power can be adjusted reely between high
and low output settings by manual rheostat control or by thermostat. The heated
air is circulated through the cabin through the warm air ducting.
In hot and/or humid conditions, these heating units can be used for simple fresh air
ventilation and circulation.
When starting the device, the glow plug ignites the pumped fuel in the burner bowl.
The glow/start and shut down sequences are actory programmed, so - starts and
stops are automatically controlled.
The fuel pump inside the heater case regulates the fuel feed and the system
electronics control both the uel and air mixture to maintain the ideal clean burning
process. The temperature sensor inside the burner feels the ignition and lights up
the red signal light (1) to indicate a successful start. When stopping the device, an
automatic after cooling process takes place. This process cleans the burner, purg-
ing any unburned fuel.
The heaters are completely made out of corrosion resistant materials.
Heater’s operation principles
D80031
- 58 -
22 GB / 30 GB
490529