8
10.5.6
F
LYBARLESS SYSTEM SETTING TEST
Step 1:
Make sure everything is off and all receiver leads are connected. Make sure main motor leads
are still disconnected
Step 2:
Turn on the transmitter power and connect the helicopter main battery, wait for binding to
complete. During this the swashplate should move up and down twice horizontal and level. If it moves
up and down at an angle then there is an error and the flybarless setup process needs to be repeated.
Step 3:
Push the throttle stick to maximum and minimum positions, repeat the process with the
elevator, aileron and rudder controls to check the movements are as expected (see section 10.5.1
Step 2). If all is not as expected then repeat the set-up process.
Step 4:
After all functions are confirmed as normal and operating disconnect the battery from the ESC
and turn off transmitter power.
Step 5:
Reconnect main motor and ESC plus complete all the usual pre-flight checks before going to
fly.
