6
10.5.3
E
LEVATOR AND AILERON GYRO FUNCTION NORMAL
/
REVERSE SETTING
Step 1: Elevator gyro reverse switch setting
Tilt the helicopter forward and check if the gyro
corrects the motion by tilting the swashplate aft. If
it tilts to the front move the ELEV GYRO DIP switch
to the other position. Re-check that the
swashplate now lilts aft.
Tilting the helicopter fore and aft, the gyro tries to
keep the swashplate level. If this is not achievable
there maybe another problem, please re-check
and if the problem persists contact your dealer.
Step 2: Aileron gyro reverse switch setting
Tilt the helicopter right and check if the gyro corrects the
motion by tilting the swashplate left. If it tilts to the right
move the AILE GYRO DIP switch to the other position. Re-
check that the swashplate now lilts left.
Tilting the helicopter left and right, the gyro tries to keep
the swashplate level. If this is not achievable there maybe
another problem, please re-check and if the problem
persists contact your dealer.
10.5.4
R
UDDER TRAVEL SETTING AND CHECK
-UP
Step 1: To enter rudder set-up mode
On the receiver, move the rudder swashplate setting switch to the “TAIL SET” position. Press the
“SET” button until the RED STATUS LED turns OFF and the rudder LED flashes GREEN. The receiver is
in rudder check-up mode.
Step 2: Check the pushrod adjustment and the reverse setting of the rudder servo.
With the rudder servo in the neutral position, the servo arm should be at 90 to the servo case &
pushrod, adjust if needed by moving the arm on the splines of the servo, by mechanically adjusting
the servo gears or by adding subtrim (it is recommended to avoid over use of subtrim). Adjust the
push rod length so the tail rotor pitch is 0.
