Assembly Instructions
21
Deck Leveling
1. Position mower on a smooth, level surface. Set
the cutting height to the highest position - 5 in.
(127 mm) - for easy access under the deck to
measure blade height. Refer to
ADJUSTING
CUTTING HEIGHT
in
Operating Instructions.
NOTE:
A block of wood cut
5 in. (127 mm)
high
is a convenient gauge to measure blade height
above ground during the leveling process.
WARNING
The machine must be shut off during this
procedure.
2. Check the side-to-side level.
Rotate the out side
blades sideways
and measure the distance
from blade tip to ground on each side. If
measurements vary more than 1/8 in. (3 mm),
adjust the height adjustment rod on the high side
to level the deck.
3. Check the front-to-rear level.
Rotate the cen ter
blade to point forward.
Measure the distance
from blade tip to ground on the front and rear.
The rear of the blade should be 1/8 to 1/4 in.
(3 to 6 mm) higher than the front of the blade;
remove the chain from the deck height adjuster
clevis and adjust equally to achieve
at least
1/8 in.
(3 mm) difference. Reinstall chains.
NOTE:
The mower deck and support frame are
jig welded; within normal tolerances, very little,
if any, adjustments should be required to level
the deck. Tire pressure will influence the level-
ness of the deck. Check the tire pressure as a
possi ble cause of the deck not being level.
Deck Leveling
Height Adjustment
Rod
Front
Rod End
Rear
Rod End
Should not vary more
than 1/8 in. (3 mm)
side-to-side
5 in. (127 mm)
Wood Block
Should be 1/8 in. (3 mm)
to 1/4 in. (6 mm) higher
at the rear of the blade
Rear
Rod End
Front
Rod End
5 in. (127 mm)
Wood Block
