walimex Niova 100 Plus Daylight, Инструкция по эксплуатации

Страница: 18 / 24

34 35
6.2 Mounting the light on a lamp stand
• Loosen the fastening screw of the lamp holder (16) until the mount can be inserted into the
attachment adapter of a suitable lamp stand or ceiling mount with 5/8 inch spigot adapter.
• Tighten the fastening screw of the lamp holder (16) again.
• Loosen the lever for the tilt angle adjustment of the lamp holder (17).
• Set the desired tilt angle of the light.
• Retighten the tilt angle adjustment of the lamp holder (17).
• The lamp is correctly installed and ready for use.
• Proceed in reverse order to disassemble the device
Application notes for tilt angle adjustment of LED Niova 200 Plus:
6.3 Mounting the soft - diffusor
By mounting the supplied soft diffuser the light characteristic is even softer and the light is more
scattered. This leads to a reduction of the light intensity at medium to long distances.
• Carefully pull the soft diffuser over the opening of the refector.
• Check that the diffusor is securely fixed.
• The diffuser is mounted.
6.4 Installation of a reflector umbrella (available separately as an accessory)
• When mounting the standard reflector on the lamp, ensure that the opening hole for the um -
brella is correctly positioned (hole for the umbrella rod shows downwards).
• Loosen the fastening screw of the umbrella reflector holder (18).
• Slide the rod of the umbrella through the opening hole in the reflector.
• Insert the rod of the umbrella into the mounting hole of the umbrella reflector holder (18) of the
lamp holder (15).
• Tighten the mounting screw for the umbrella holder.
• Check that the umbrella is securely fixed.
• Proceed in the reverse order when disassembling the umbrella reflector.
1. To adjust the LED Light,
pull out the direction adjus -
ting handle, then turn the
handle clockwise to tighten
the adjusting screw or turn
the handle anticlockwise to
loosen the adjusting screw.
2. The direction adjusting handle‘s rotation angle is res -
trained from 0 to 180 degrees below the body. To adjust
the direction adjusting handle by 360 degrees, pull out the
handle, adjust to the appropriate angle, then continue with
step 1 while making sure that the handle does not touch the
body.