Do not operate the device with wet hands or feet.
Clean the device exclusively as described in this instruction manual.
Ensure that cables and conductors are not damaged. Damage could be
caused due to heat impact, chemical influence or due to mechanical
impacts such as rubbing, bending, tearing, rolling over, or nibbling
animals.
Prevent your device from falling.
In the case of falling, please have an electrician check the device before
switching it on again.
If your device is damaged or if you notice a burning smell:
Disconnect the power supply immediately by unplugging the power
cord and removing the battery. Never operate your device with a
damaged casing, defective reflector, defective modeling lamp, defective
flash tube or a damaged power cord. Do not open the device. Never
repair the device on your own. Have the device repaired exclusively by
an electrician
Please follow this instruction manual for maintaining your device.
Please only use spare parts which are conform to the required
specifications. See
Technical specifications
.
WARNING
Danger of fire by overheating
The device can overheat if you operate it with mounted protection cap or
with covered ventilation slots. The device itself or easily inflammable
materials in close distance could catch fire.
Do not operate the device with mounted protection cap.
Do not cover the ventilation slots of the device during operation.
Remove easily inflammable materials from the surroundings of the
device.
Please exclusively use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
WARNING
Danger of fire due to hot device components
The modeling lamp and flash tube could heat up to 240°C and the reflector
up to 75°C. Easily inflammable materials could catch fire, if they get in
contact with hot device components.
Do not cover the ventilation slots of the device during operation.
Remove easily inflammable materials from the surroundings of the
device.
WARNING
Danger of burning on hot device components
The modeling lamp and flash tube could heat up to 240°C and the reflector
up to 75°C.
Do not touch device elements during use and during the cooling down
phase.
Allow for device to cool down for 30 minutes before beginning assembly
or maintenance measures.
WARNUNG
Danger of cutting and splitting due to breaking modeling lamp or
breaking or bursting flash tube
Even small residues of skin oil on the flash tubes can lead to the splitting
of the flash tube, due to the high heat impact during operation. Broken
glass can hurt eyes and skin.
Treat the modeling lamp and flash tube carefully to avoid them from
breaking.
Do not touch the flash tube with bare hands. Use a clean cloth or clean
gloves.
Avoid touching the flash tube accidentally when mounting or changing
accessories.
7
6
